PAUL BRACH KNIVES
HOME
ABOUT
PORTFOLIO
Process
Teaching
CONTACT
Anvil story
Wedding Cake Knife
First Damascus Blade
More
I use the 8" round wheel to true up the edge symmetry and remove as much of the steel as I can before going to the flat platen
After establishing the symmetry, I move to the flat platen and refine the geometry of the bevels and take the knife down close to final dimensions before heat treating
Now I am ready to heat treat.
Blade has just cooled out of the quench oil and still shows scale and colors from the quench
I took this one down to about 220 grit on the grinder after heat treat and then switched to hand polishing at 220,320 and 400 grit. I polished 2 directions at 400 grit and then pulled a clean satin finish down the blade. I went over it with 600 grit loaded with Schimichrome for the final finish